Still working to finish the kitchen area by constructing a ceiling cabinet on the side wall behind the wardrobe. It will function as a storage area for plates, bowls, mugs and other items, that I use on a daily basis during food preparation. Kitchen Cabinet One limitation I have, is that the finish material Formica… Continue reading Kitchen Cabinet & OBD2 Scanner
Category: Members Only
Onboard Compressor
Besides the traction boards and the come-a-long, I still have an issue with deflating and inflating of the tires, in case I get stuck in mud or sand or when I drive over long stretches of washboard road. Not long ago I decided to bring along my old, but oh-so good working 110V Campbell compressor… Continue reading Onboard Compressor
RV Kitchen Cleanup
In this final stretch, I finish and install the countertop, add some Formica around the fridge and a panel surrounding the side kitchen window. Countertop The countertop is finished with four coats of Shellac and three thin coats of Poly-Urethane on top. Before I install it, one or two coats of regular furniture wax, will… Continue reading RV Kitchen Cleanup
Traction Boards Hardware, Wiring and Countertop
I am working around the kitchen area of the van, to finish the countertop, pull a remaining wire behind the fridge to the battery compartment below it, add some Formica strips to finish the fridge cabinet and to install the traction board hardware. Previously I had temporarily installed the half-finished cover of the induction cooktop,… Continue reading Traction Boards Hardware, Wiring and Countertop
Desk Seat Cushion
This week I’m finishing up my desk seat, by adding a cushion. The seat can be used as part of a lounge chair, in combination with the rear-facing passenger seat, but it’s primary use is at the fold-down desk, that will be attached to the Murphy bed. I chose a 4-inch, high-density foam core as… Continue reading Desk Seat Cushion
Mobile Router Table 2
The foldable router table is taking shape and will play its part in my life on the road. I continue to assemble the box by adding supports for the hinged router plate. The top of the box consists of two 1/2 inch plywood panels. Build I finish the wings, while the glue-up is drying. More… Continue reading Mobile Router Table 2
Mobile Router Table
To take one of my hobbies on the road, I need to build a mobile router table, that folds up small and fits into a small cabinet. Build The design first has to be adjusted to the storage area and some hardware needs to be ordered. Only then can I start with the build by… Continue reading Mobile Router Table
Safety & Rescue Gadgets
After working some more on the kitchen countertop, I sit down and show some of the safety and rescue items that should be part of any Vanlife experience. Especially, when you head out to boondock or while off-road driving. Kitchen Countertop The movable part of the countertop, that hides the induction cooktop, returns to the… Continue reading Safety & Rescue Gadgets
Kitchen Countertop
It’s time to finish the kitchen area of the van and that also means a new hardwood countertop! As always, I start rough-sawn hardwood and I chose Mahogany again, to stay consistent with the other countertop at the sliding door. It’s easy to work with and has usually an attractive pattern. I had one piece… Continue reading Kitchen Countertop
Induction Cooktop
I continue working to finish the ceiling in small increments; this time above the wardrobe closet. The main focus this week is on the installation of the induction cooktop. The storage for this cooktop is under the kitchen countertop, where I have a tray to store it in and some more storage space under that.… Continue reading Induction Cooktop