After my last post, I took a short brake, but now I’m refreshed and at it again. We are in the final stretch of the multi purpose cabinet and next time I hope to have it ready to install in the (cargo) van conversion. Meanwhile, to prevent any noise made by the cooktop cover while… Continue reading Multi-Use Cabinet (8)
Category: Electrical
Multi-Use Cabinet (6)
A lot of time is spent on this multi purpose cabinet in pursuit of a high standard of finish. When it is ready and installed in the next two weeks, I will continue with the cargo van conversion. There’s the solar prep and walls & floors to be finished. Previously I installed a Romex… Continue reading Multi-Use Cabinet (6)
Multi-Use Cabinet (3)
Fitting the cabinet in the van The RV’s cabinet overhangs the step-in area at the side doors. A simple box with a Cherry front will fill that in. The extension at the top of the will cover the end of the core bottom panel. As we are approaching glue-up, it’s time to check… Continue reading Multi-Use Cabinet (3)
110V Wiring (2)
Besides a 110V outlet at the rear doors, a second outlet is planned at the side door entry. I start with a regular Romex house wire in the inverter compartment under the bed. An inverter will be added in a later stage. Because the compartment is directly next to the wheel housing, I have to… Continue reading 110V Wiring (2)
110V Wiring
To continue work on the bed, the 110V outlets are next. A small and simple job. The only 110V will be available at 2 outlets, one at the side entry doors and the other at the rear doors. They will both be connected to an inverter. I started with a shallow outlet box at the… Continue reading 110V Wiring