Watch all my videos on YouTube! I continue with the smaller details of the kitchen cabinet in preparation of the water supply & drain and several electrical cables.
Tag: workshop
Induction Cooktop Tray
Watch all my videos on YouTube! Building a box into the kitchen cabinet, that will hold the induction cooktop. Finishing it off with some Formica.
Kitchen Cabinet Assembly
Watch all my videos on YouTube! I’m continuing with the kitchen cabinet assembly in the RV. It’s mostly gluing the separate parts together, but I sometimes use screws, allowing me to access hidden parts of the kitchen cabinet. After another fit in the cargo van, I outline the location for the induction cooktop, but that’s… Continue reading Kitchen Cabinet Assembly
RV Ceiling & Kitchen Setup
Watch all my videos on YouTube! Now that the Murphy bed is installed, I continue with the kitchen area. It’s basically one cabinet, flanked by two narrow sliders. It will hold the sink, water heater and ‘Shower-in-a-Drawer’. Because it’s only a small cabinet and to
Thinking About Safety & More
Watch all my videos on YouTube! Safety comes in different packages and I start with a fire extinguisher in the RV/Cargo Van. I just installed a general purpose extinguisher next to the driver’s seat and will add another one at a later time, either in the kitchen or at the sliding side door of my… Continue reading Thinking About Safety & More
Neodymium Magnets In The Murphy Bed Legs
I’m putting the finishing touches on the Murphy bed and added two strong magnets to each leg. The legs of the fold down bed have to be secured in two places. When the bed is pulled down, the legs should be extended and held in a 90 degree position and not over-extend.
Picture Frame & Canvas
Watch all my videos on YouTube! In an effort to finish the driver’s side of the interior, I prepared a molding for the bottom of the Murphy bed and started to replace the fill dish and hoses at the fresh water tank. The wardrobe side wall also got a Formica finish. In addition, I started… Continue reading Picture Frame & Canvas
Murphy Bed Legs
Watch all my videos on YouTube! In the coming weeks, I’ll be finishing the Murphy bed. Today I move the bed back into the van; it’s time to take some final measurements and add the legs. I use a similar pivot mechanism on both legs and some magnets to keep the legs in place when… Continue reading Murphy Bed Legs